|Prev||Professional Automotive Repair Technical Discussions for November 26, 2005
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for European
|2000 Audi A6 2.8L Misfire, MIL Lamp on VIN: WAUBH24B1Y
I've had this car since yesterday, and it has the hard code 0304. This Audi runs smooth when temp is low, but starts mifiring at or about 140 degrees. I went straight into the fix database here and checked out a few things that fixed others like this. There wa... Trouble codes: 0304 (misfire on 4 cyl), 0118 (pending code for cts)
|1994 Mercedes-Benz C250D 2.5L No Start VIN: WDB2021252
As we do not get many diesel pasenger cars here in New Zealand,and especially not many Mercedes diesels I like to ask you people for some help.Car has Bosch in line pump with electronic control on it,but NO sensors on injectors.A few days ago car was towed in ...
Fixes & Summaries for European
|2002 Audi Allroad Quattro 2.7L Ride Height VIN: WA1YD64B92
Looks like the LF Air Bag is leaking. It will be replaced the next time the car is in for service.
|1990 Mercedes-Benz 500SL 5.0L camshaft VIN: WDBFA66E7M
thanks all for help.i lapped the few valves that were leaking and reassembled the engine replaceing guides/chain/oil pickup.started first try and is running fine with the exception that mixture control unit has one cyl running lean.fattened mix till customer h...
|1997 Saab 900 SE Turbo 2.0L No Start VIN: YS3DF78N8V
The problem was the ignition module pack, which the vast majority of the responses mentioned as the most likely no-start cause. One response gave detailed handing advise which said that the module should not be stored upside down and as a precaution, should be...
|2004 Volkswagen Beetle GLS 1.8L Glove Box VIN: 3VWCD21Y94
Well...first rule is...install the lock cylinder barrell CORRECTLY...here's how its done...orient the cylinder tit/cam at 3 o'clock as the cylinder is being installed...push till it snaps in..now when the key is in the lock, the normally open position is 12/6 ...