|Prev||Professional Automotive Repair Technical Discussions for November 20, 2005
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1992 Chrysler LeBaron 2.5L hard start when cold VIN: 3C3ZA46K0N
Vehicle came in with a no start condition engine computer inop replaced, also replaced plugs wires cap rotor car runs pretty well does have a flucuating idle problem at times when in gear(seems to idle a bit low at times) found 02 sensor flat lined replaced wo...
|1996 Chrysler Sebring JXi 2.5L No Start VIN: 3C3EL55H7T
I have checked power to the injectors and there is no pulse. I also checked fire. No fire to the plugs. Does this mean the cam position sensor is bad. I do not have access to a oscilloscope at this time to check the sensor. The cam sensor is in the distributor...
Fixes & Summaries for Chrysler
|1996 Dodge Caravan ES 3.3L No Start, blows fuze VIN: 1L0552L521
Well it's fixed after going in the wrong direction for the first few hours. When a fuze blows I look for shorted wires so I started chasing all the circuits on that fuze from the wiring diagram. I could not find any wires shorted to ground. At first the engine...
|1996 Jeep Grand Cherokee Limited 5.2L belt VIN: 1J4GZ78Y7T
We went with a 7 row belt instead of a six row to bypass the ac compressor since it looked better with all the ribs on the pulleys filled. -we went with a Ko70786 which fit well but we had to take the compressor off to allow for belt routing -the compressor ca...