|Prev||Professional Automotive Repair Technical Discussions for September 24, 2005
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2001 Chrysler Town & Country (Van) EX 3.8L heated mirror VIN: 2C4GP54L51
This one is for the Chrysler electronic techies .This is my wife's van,the drivers side mirror glass is broken,I thought it was not heated. It is heated and I would like to know if I have to ohm out the old mirror and put in a resistor to replace the heated mi...
|2002 Jeep Wrangler SE 2.5L Hesitation, MIL Lamp on VIN: 1J4FA29P32
Scan tool shows TP volts KOEO 4.57v. Check for short to B+ with PCM connector 'A' and TPS unplugged. KOEO there was 5.7 volts on TP sensor signal wire. Unplugged map sensor and voltage dropped to 0v. Suspect short in harness(or map sensor) but the 3 TPS wires ... Trouble codes: P0123 (tp sensor voltage high)
Fixes & Summaries for Chrysler
|1997 Chrysler Town & Country (Van) LXi 3.8L Front Wipers VIN: 1C4GP64LXV
The van wipers are still working fine at this time, talked to the customer yesterday, hasn't had any problems, If it has any problem in the future I let you all know. Can't say what really fixed the problem, must be a connection at the switch or the BCM is giv...
|1997 Chrysler Sebring JX 2.4L No Start VIN: 3C3EL45X9V
This ones fixed, Feel a little dum, thought I had checked all the wiring for shorts, but I missed a spot. One sugestion was to cut the 8 volt supply wire to pin 44 close to the computer, and see if my 8 volts appear, and if it did, then start looking for your ...