|Prev||Professional Automotive Repair Technical Discussions for May 26, 2005
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1993 Dodge B350 5.9L Misfire VIN: 2B5WB35Z1P
truck has misfire under load at intermittent times. scoped tested engine and all ignition patterns look good and with no visible change when problem occurs. followed tsb's for distributor indexing and also changed distributor, computer,crank sensor, secondary ...
|1998 Dodge Ram 1500 Truck 5.2L ignition VIN: 1B7HF13Y5W
vehicle came in with an intermittent hard crank and inspect brakes.In spected charging system,load tested battery,prefromed voltage drop test.While cranking at times amp draw was exceeding 290amps. Sounded like classic bad starter. After replacing problem stil...
|2000 Dodge Durango 4.7L Mechanical
Hello IATN members. I have this Durango that seems to have a head gasket problem. While cranking engine with rad cap off water gushes out, and with pressure tested attached I get about 7PSI of pressure in cooling system while cranking. But does not seem to ...
|1987 Jeep Cherokee Pioneer 4.0L No Start, Stall VIN: 1JCMT7825H
help, Thanks in advance to all the great help you guys give to each of us. The customer had this jeep towed in about 10 days ago, with a no-start. We first checked the crank sensor and found it to be open, so we replaced it . Then had an intermittent , but ver...
Fixes & Summaries for Chrysler
|1999 Chrysler Intrepid 2.7L Stall VIN: 2C3HH46R8X
Thanks for all the help. I checked the wiring at the crank sensor and it was good, cleaned the throttle body and IAC, replaced the IAC, and replaced the fuel pump, but nothing helped. My co-worker took it for a couple of rides, and after awile he noticed the E...
|1994 Dodge Caravan 3.3L No Start VIN: 1B4GH44ROR
Well this one is one that we chalk up to the rule that you always go by procedure. after all the great emails from all the great techs out there, we tried dropping the exhaust, and a rebuild ecm and still came up with a no start. after all the checks, we went ...
|1999 Dodge Intrepid 2.7L No Start
thanks to all specially to those that pointed to crank sensor sorted to ground intermittent, very hard to find ,but without your help would be almost impossible thanks to every one again