Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 8, 2005
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1995 Ford Taurus GL 3.0L rear wheel cylinders VIN: 1FALP52U3S
just did brake job went to back out both rear cyl. blew out never had this before need help
View
1998 Ford Escort ZX2 Hot Coupe 2.0L Mechanical VIN: 3FAKP1133W
engine starts to make a squeeking noise after a minute, loosen up oil fill cap noise goes away, checked pcv,pulling no vacum through end of pcv, new one same way no help,can some one explain why the pcv works this way, and how to get rid of the bad squeeking n...
View
2000 Ford Taurus LX 3.0L Unknown
car wont shift till around 4000rpm then shifts hard, shapon scanner shows a pid for shift seloniod fault but always says no, fluid is clean and full,my GUESS is bad selinids but is there any other things to check first or any other test i should make before tr...
View
1999 Lincoln Town Car 4.6L comprfessor VIN: 1LNXY81W24
I have an inoperative A/C compressor and have determined that the pcm is defective. I want to replace the pcm with a used, known good pcm, however I need information regarding programming the pcm or the pats key with my NGS. As the Ford techs know, the car won...
View

Fixes & Summaries for Ford
Fix/Summary Answers
1997 Ford Ranger Splash 2.3L Poor Idle Quality, Hesitation VIN: 1FTCR10A6V
Thanks to all the members who replied to my help request. I have delayed closing my request because the shop where I work has purchased a Hickok scan tool and the flash system for computers. We have not been able to get the flash part up and running because of...
13
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next