Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 7, 2005
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Asian
Help Request Answers
1998 Isuzu Rodeo LS 3.2L power door locks VIN: 4S2CK58W34
hi all tech , thank in advance for any ideas on this truck , this car have originally keyless entry not unlocking and lock from passerger front and both rear door it only unlocking drive door but can not lock. it also can not unlock either drive and pass door ...
1996 Toyota Corolla 1.6L Surge, Cuts out VIN: 2T1BA02E4T
When Cold Engine Will Run Fine After 10Min. Engine will Cuts Out & Missfires. Spark & Fuel Del. Ok, Injectors Are Cuttting Out Loosing The Ground Side. Lab Scoped Crank Sensor,Ignitor,Cam Sensor All Ok. Checked & Cleaned All Grounds & Volt Drop Ok. Replaced EC...
2004 Toyota Tacoma Pre Runner 3.4L Alarm VIN: 5TEGN92N64
Hey guys, Hope someone can help me with this alarm concern. I have the factory keyless entry (via remote) and it beeps once when locked and twice when unlocked. It also unlocks the drivers door with one push and all others with two pushes. My problem is that I...

Fixes & Summaries for Asian
Fix/Summary Answers
2002 Honda Accord Value Package 2.3L Vibration on acceleration VIN: 1HGCF866X2
Firstly, my thanks to all who responded. I apologise for the delay, however I had to wait for my customer to return. I have changed many timing belts and my usual technique is to mark the old belt and the gears and transfer the marks to the new belt to save ti...
2000 Hyundai Sonata GLS 2.5L Cuts out, Stall, MIL Lamp on VIN: KMHWF25V8Y
This vehicle had multiple problems and we only fixed one of them. The stalling problem turned out to be the Torque converter intermittently locking up so when the vehicle was stopped it would stall. The customer 'needed' the car so we never found the source of... Trouble codes: P0740, P0335 (crank pos sensor fault), U3118 (undocumented code), C0307 (undocumented code).
1993 Lexus LS400 4.0L Unknown VIN: JT8UF11EOP
I feel that this is a drain back issue as Larry from NY said. I did try a transmission flush and filter change. there was very little debris in the pan and the fluid was super clean. the customer decided to let the vehicle warm up for a little while before dri...
1998 Mazda Protege DX 1.5L Hesitation, Misfire VIN: JM1BC1414W
I apologize for the long delay in closing. Customer has not contacted us up untill a couple of days ago. Has indicated that car is running better with fewer occaisions of 'missing and hesitating' but it is still occuring. We took a quick look at the MAF sensor... Trouble codes: P0301.
1993 Nissan 240SX 2.4L shift points VIN: JNEMSE7AOP
Jon and Philip hit this one. The car actually was doing a 1-3 shift. Upon pulling the pan and inspecting, there was alot of clutch/band material in the pan. So it is off to the rebuilders. Thanks for the insight guys..
1988 Toyota Pickup 2.4L Hesitation, Stall, Misfire VIN: JT4RN50R4J
Thank you all for the help and ideas. Everyone was helpful. To Scott, I checked the air pump. It was a good possibility, but it checked out okay. To Jim, I checked the fuel pressure, and it checked out okay as well. To Jeff, I could see where the accellerator ...
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next