 Prev |
Professional Automotive Repair Technical Discussions for May 1, 2005 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2003 Honda Civic LX 1.7L Battery Lamp/Alt VIN: 2HGES16543 This vehicle has a battery lamp that flashes rapidly on a cold start up with battery voltage @ 12.06 and 0 amp output. This condition will continue until until a load such as cooling fan cycle or the heater is turned on. As soon as a load is detected the flash... |
View | |
| 1985 Mazda 626 DX 2.0L Excessive Emissions, Poor Idle Quality, Stall, EGR VIN: JM1GC221XF EGR Vacuum signal does not vent on decel,stalling engine at idle,removed and inspected vac control solonoids,check out ok,also checked position sensor,checked out ok,Thanx in advance for any suggestions. |
View | |
| 2000 Nissan Frontier XE 2.4L Overdrive VIN: 1N6DD26S4Y Dear iATN members, Transmissions are not my forte; nonetheless, I've been handed this truck. TIA for reading and your patience. The mileage is correct--pushing five hundred thousand--and this engine continues to run acceptably. The bad news is that, five day... |
View | |
| 1988 Toyota Pickup 2.4L Hesitation, Stall, Misfire VIN: JT4RN50R4J this is my old trusty is/was very reliable..now my cat. converter runs cherry red at times ??? replaced new cat. EGR valve and tube,fuel pump,filter,plugs wire cap...dry gas in tank,did motorvac idles nices.when revved hear some backfire plan to replace muffle... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 1996 Nissan Maxima GLE 3.0L Cuts out, MIL Lamp on VIN: JN1CA21D9T thanks for the help guys. it turns out the owner put 'splitfire' plugs in a while ago. problem started a few months later. there must have been RFI ( radio frequency interference ) causing the cam sensor code and screwing up the signal. Thanks to identifix for... Trouble codes: P0340 (Cam sensor). |
5 |
