
![]() |
Professional Automotive Repair Technical Discussions for February 26, 2005 International Automotive Technicians' Network (iATN) - Members Only |
Next ![]() |
(Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. |
Open Help Requests for Chrysler
Help Request | Answers | |
2002 Dodge Durango SLT 4.7L Poor Idle Quality, Stall, Misfire, MIL Lamp on, HARD TO START VIN: 1B4HS48NX2 Hi everybody: this car has me lost, came in the shop for rough idle, and mil on, check and p0335 was in memory. Check harness and voltage and everything ok so i replace sensor, clear codes car seemed to run ok, the same day car comes back with same code, but... Trouble codes: P0300 (multiple misfire), P0335 (crank sensor circuit) |
View | |
1994 Jeep Wrangler S 2.5L Backfire VIN: 1J4FY19P6R I posted this earlier, but think I did it wrong. Hope this is the correct place to post it. I have a 1994 Wrangler with a 2.5L VIN "P" in the shop. It has no power and is backfiring out through the exhaust at part throttle. Does not matter if there is a load ... |
View | |
2003 Jeep Wrangler X 4.0L cruise control VIN: 1J4FA39S23 Hi all, here's a very weird one for you! We had a new customer (why a new one to do this to!) bring his [...] 4.0 5 speed to us to install cruise control. We thought the best thing to do would be to install factory cruise. Everything went well, had to a... |
View |
Fixes & Summaries for Chrysler
Fix/Summary | Answers | |
1995 Chrysler New Yorker 3.5L cluster gauge/lights VIN: 2C3HC46FXS thanks guys,i looked up wireing and put a test light on fuse to i/p # 17 and 14 , turned on ignition switch and no power for 3 sec then pwr and gauges,installed oem switch and works great,thanks again |
5 | |
1999 Dodge Intrepid 2.7L Timing Chain VIN: 2C3HH46R7X The problem was a bad tensioner. It looks like when it warmed up the tensioner was colapsing back into it's bore. The dealer didn't want to believe me that it was a tensioner issue. They wanted to blame it on low oil preesure or plugged oil galleries, which I ... |
10 |