Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for December 27, 2004
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1994 Ford Mustang 3.8L Misfire VIN: 1FALP4043R
edis ign. no turbo or sc. skips on 3 and 4 cyls which are companion cyls. no primary trigger signal to coil for 3 and 4. tried new coil and module. crank waveform good. pip and spout ok, even disconnected spout. a 95 engine was used but the correct coil and mo...
View
1995 Ford Explorer XL 4.0L transfercase VIN: 1FMDU34A6S
This SUV has no 4wd operation.Owner bought new and has not used 4wd much at all.The 4wd switch seem to be working properly. It will go from 2wd to 4wd(high) and if I stop put in neut. foot on brake switch to 4wd (low) I can hear the motor clunk into gear. If I...
View
1998 Ford Contour SVT 2.5L engine/trans VIN: 1FAFP68G9W
Hi Techs, Need some advice from someone who's been there on this one. This is an SVT contour with the Duratec V-6 by the way. Engine is blown and I need to pull for rebuild. I'm looking at clearances and it looks dicey. With the standard tranny I don't have r...
View
1999 Ford Windstar SE 3.8L MIL Lamp on VIN: 2FMDA5247X
This Vehicle continually sets P0171 and P0174 both banks lean, Vehicle runs fine, no gas milage complaint, we have tested for vacuum leeks, checked MAF and MAF plumbing, Fuel pressure 36 PSI regulator connected and 44 regulator disconnected, we are stumped on ... Trouble codes: P0171 (B1 lean), P0174 (B2 lean)
View
2001 Ford Escape XLS 3.0L timing cover VIN: 1FMYU01A1K
Hello and thanks in advance for your help. The timing cover on this 3.0 Escape is leaking oil. The oil pan gasket has been replaced earlier and is dry now. Mitchell info says Ford requires engine removal first before doing cover removal. This does not appear t...
View

Fixes & Summaries for Ford
Fix/Summary Answers
1994 Ford Ranger XL 3.0L Transmission / drivetrain
I want to thank everyone who offered assistance to FIX this 'clunk', unfortunately the customer has not returned their truck. The majority of help suggested lubing driveshaft splines (that is my first thing to do), after that I'll dive into the rear end. By th...
16
1994 Ford Tempo GL 2.3L Hesitation, MIL Lamp on VIN: 2FAPP36X7R
Thanx for all the replies guys. Cust. decided he woeld live with the light until something breaks. Trouble codes: 186 (injector pulse high or maf to low).
7
1999 Ford F-150 4.6L Misfire VIN: B676791149
hi techs : thanks for all the information,well i took the trottle body of and cleaned the egr passages.these passages were blocked with carbon. i also change the spark plugs do the drive cycles and now the vehicle is working is working good . the costomer is... Trouble codes: P0401 (p1000-), P1000.
36
2002 Ford Crown Victoria 4.6L No Start VIN: 2FAFP71WX3
Thansk to all that replied, after all this it turns out it was a fuel pump. We had driven the car for 4 days with a gauge on the windshild but could never get the car to act up. we scoped the pump motor two times and never saw anything wrong. On a hunch I tied...
17
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next