|Prev||Professional Automotive Repair Technical Discussions for December 19, 2004
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for European
|2000 Jaguar XKR 4.0L MIL Lamp on VIN: SAJAA42J5Y
Need some Guidance on this one.If I clear these codes and retest. I get the P-1720 code without the p 1721.Once i cycle the key I get the rest of the codes The IPC is stating the Brake fluid is low, the cruize is not operating , the engine is in fail-safe mode... Trouble codes: P1720, P0447, P0453, P1108, P1637
|1997 Land Rover Range Rover HSE 4.6L drivetrain VIN: SALPV1440V
This vehicle has what I would describe as a noise like spline are slipping on a shaft.Transmission just repaired for a bad sprag in the front planet.Did not fully believe that was also the noise problem ,but was required anyway.The left rear axle seal was repl...
|1991 Volkswagen Jetta 1.8L Cuts out, Stall, shuts off at cruise VIN: WVWPAD1G2N
Hi fellow techs! This VW is driving me crazy!Customer says car shuts off while driving/cruising.He can then start the car right away.It does it at least once a day,sometimes 7 or more times a day. It has never done it for me!(of course!)The last thing i did to...
|1998 Volkswagen Golf GTI 2.0L MIL Lamp on VIN: 3VWDB81H6W
Thank you for help in advance. VW came in to the shop with check engine light on. Customer states light came on after they bought the car from a used car dealer. Pulled codes P0442A came up on scanner, small evap leak detected. Smoke tests system and no leaks ... Trouble codes: P0442 (small evap leak dect)
Fixes & Summaries for European
|2000 Land Rover Discovery Series II 4.0L CO in cooling system VIN: SALTY1249Y
I'm posting this as fixed even though it's not quite done yet. All 7 responses indicated problem's with engine block leaking around liners. Special thanx to Brooks and Ken for giving me ideas on pressure testing the engine block myself. We borrowed plates from...