Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for December 17, 2004
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1995 Chrysler Cirrus LX 2.5L engine VIN: 1C3EJ56H5S
This is a mind blower. Towed car in with a no start. (starts runs three seconds and dies) Lights blink and horn honks as if alarm is activated, but GET THIS the vehicle does not have an alarm system that I can find anywhere. No key chip, no anti theft module, ...
View
2000 Chrysler Grand Voyager SE 3.3L int cluster VIN: 1B4GP44RYB
have any you chrysler tech had this i seem to lean towards a body ecu but at about $700-00 i would like to know if i am correct . the intsrument cluster does not light up the rear wipers or defroster do no work the ckeck eng light and abs light is on even thou...
View
1990 Dodge D150 5.9L Hesitation VIN: 3B7GE13Z6L
egr valve is pulling wide open when throttle is opened slightly. tps was bad but replacing sensor did not correct problem. the solenoid for the egr valve is normally closed and when we open the throttle we lose the ground signal to the solenoid allowing full v...
View
1992 Dodge Stealth R/T Turbo 3.0L No Start VIN: JB3XE74C5N
car arrived today on hook no start ck for spark .none perform no start tests and the first thing to check is codes noticed that the scanner wouldn't recieve any codes or data performed tests for that and found the ecm is bad. removed ecm .i wanted to look in s...
View
1994 Dodge Caravan 3.0L oil leaking from front of motor VIN: 2B4GH2537R
This oil leak looks like it is coming from above crank and was wondering if these 3.0 have a comman problem with oil leaks. Before I start getting to deep in to it. Oh by the way the die does not help because I found out after I put it in that the owner put di...
View
1996 Dodge Caravan 3.0L Cuts out, Stall VIN: 2B4FP2532T
this van has had an intermittant stalling problem. After driving a while, it will act as if fuel goes away and van stops running. After letting it sit for 10-15 minutes, it would re start and run fine for hours, days or weeks. It will throw a P0300 random misf... Trouble codes: P0300 (Random / multiple cylinder misfire detected)
View
1997 Dodge Ram 3500 Truck 5.9L Misfire VIN: 1B6MC3659V
This Dodge can't get out of its own way when going over 20 MPH.It pops back throughn the throttle body when you really step on it. Last I drove it I couldnt go over 40 MPH.Removed both upstream o2 sensors and drove it, no better.Inj Sync test says fine.No Schr...
View
2001 Dodge Ram 1500 Truck 3.9L Misfire, MIL Lamp on VIN: 1B7HC16X01
swapped injectors, ckd plug wire to #5 4.9k ohms cap & rotor looked ok, problem occurs on start up cold, the colder the longer it misfires. Trouble codes: 305 (cyl 5 misfire)
View
1997 Jeep Grand Cherokee Laredo 4.0L Cuts out, Stall VIN: 1J4FX58S5V
This jeep has been all over town- it will shut off on a prolong idle mainly after the jeep has been sitting- there is a new battery and conections are clean. all grounds have been cleaned- My scan tool may have caught a p0320- crank signal lost but no check en...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
1991 Dodge Dynasty 3.3L shuts down VIN: 1B3XC46R4M
At the recomendation of several of the IATN members, took second look at the cam sensor. When originally monitored it with diagnostic computer during running, it had a signal. Now noticed that it still has a signal while running , but once engine shuts down an...
10
1997 Jeep Wrangler SE 2.5L Accessories VIN: 1J4FY29P4V
Faulty pcm guys, thank you for your help. Must be time for a factory chrysler scan tool.
8
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next