Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for November 8, 2004
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1967 Chrysler charger 383CID turn signals VIN: XP29H72361
Right turn signal works fine. Left turn works OK until you press the brake pedal. Stops blinking and stays on solid. Anytime you press the brake pedal the left indicator light in dash lights up with or without the left signal on.. Lights up even when you unplu...
2000 Dodge Grand Caravan SE 3.3L Speedometer, fuel and temp guages VIN: 1B4GP44G4Y
This caravan came in for several dash warning lights on and no guage operation. I ran a scan test and found the only computer communicating was the PCM I had no communication with the TCM, ABS, and MIC modules. I backprobed the ccd bus at the diagnostic connec...
1997 Jeep Wrangler SE 2.5L Accessories VIN: 1J4FY29P4V
On this jeep the temp gauge, oil pressure gauge and fuel gauge do not work. It is no surprise that these are the gauges that get there info off the ccd bus. Checking the ccd bus lines reveal 2.51 volts and 2.49 volts with the minor variations expected with dat...

Fixes & Summaries for Chrysler
Fix/Summary Answers
2000 Chrysler Concorde LX 2.7L transmission VIN: 2C3HD46R9Y
Well this car had multiple problems . Updated trans control module helped .It still had code 725 ,no engine rpm signal . The input speed reading would also drop out at times. Replaced input speed sensor, that fixed input rpm drop out . If I wiggled PCM harness...
1989 Dodge Dakota 3.9L Poor Idle Quality, Poor Fuel Economy, Rich at Idle VIN: 1B7GG26X0K
Thanks for the many replies. We have identified the problem as the EGR vacuum transducer. Apparently there was a bit of rust from the EGR valve got into the transducer and allowed a small amount of vacuum to hold the valve slightly open at idle. Replacement of...
1994 Dodge B250 5.2L Starting VIN: 2B7HB21Y5R
Thanks guys. Got a new ECM and installed this morning. Tried it first with same symptoms, swapped ECM and it flashed right up!! Good riddance !
1996 Dodge Grand Caravan ES 3.3L No Start VIN: 1B4GP44ROT
I recieved A lot of help from 24 very knowledgeable technicians and would like to thank each and everyone of you for your suggestions. This is not the first time nor will it be the last time I've had my rear end kicked by monster from Dearborn , Detroit or J A... Trouble codes: P0340 (Cam Sensor Malfunction).
1998 Dodge Grand Caravan 3.3L MIL Lamp on VIN: 1B4GP44ROW
clear mil light no vehicle light has not came on since.? Trouble codes: P0455.
1999 Dodge Dakota 5.2L Poor Idle Quality VIN: 1B7GG22YOX
thanks guys we did find the intake leaking vacuum, removed intake and replaced all related gaskets and engine ran fine, thanks again.
1993 Jeep Cherokee Sport 4.0L clutch VIN: 1J4FJ68S4P
fixed! I replaced the clutch with a LUK repset, gave the flywheel a light turn, and made sure that everything, I do mean everything was clean. come to find out that all the other shops were using Crapa, I mean Napa brand clutches, even the jeep dealer. The cus...
1997 Jeep Grand Cherokee Laredo 5.2L front diff VIN: 1J4GZ5856V
thanks for all that gave us imformation/its not fix yet still trying to get the the jeep back in. thanks agian
1998 Jeep Grand Cherokee Limited 5.2L Driver's Information center VIN: IJ4G278YOW
According to the message I got from the owner of the shop with this vehicle, the problem was in the BCM. He said that they checked for loose grounds and shorted wires in the area of the heater core and found none. Then they removed the BCM and opened it. They ...
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next