|Prev||Professional Automotive Repair Technical Discussions for October 31, 2004
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1993 Jeep Cherokee Sport 4.0L clutch VIN: 1J4FJ68S4P
I have this jeep, brought to me by the customer. It has had been to 3 other shops in the past year for a very touchy/chattering clutch. all of the other shops installed new clutches, NAPA and Carquest parts, the last shop installed a new flywheel and clutch ma...
|1998 Jeep Grand Cherokee Laredo 4.0L front-end VIN: 1J4GZ48S9W
hello, I hope there are some jeep techs out there that have seen this before, I'm going nuts here, this jeep makes a hollow knocking noise on turns, sounds like it's in the body up front, mostly on right turns but also heard somtimes on left turns,the noise be...
|1993 Plymouth Grand Voyager LE 3.3L Limp In Strategy VIN: 1P4GH54R0P
Hi All: Been in and around approx. a thousand of these 604's and this is a first for me. This one when checked with key on engine off shows no limp strategy. As soon as you start the engine, after approx 5-10 seconds without any vehicle movement it goes into l...
Fixes & Summaries for Chrysler
|1998 Jeep Cherokee Classic 4.0L No Start VIN: 1J4FT68S1W
Thanks to all that responded. It did turn out to be a crank sensor, it was shorting its 5 volts to ground as soon as I unplugged it I began to get communication. I cannot thank you all enough. It's good to know this network exists. I'm sure it will be a very u...