|Prev||Professional Automotive Repair Technical Discussions for October 9, 2004
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1999 Ford Windstar LX 3.8L dash lamps VIN: 2FMZA5144X
This Windstar does not light up most of the instrument cluster warning lamps, i.e., check engine, turnsignal indicators, battery, temp, etc. even for a bulb check. However on occasion it will turn the lamps on when you go to turn the ignition switch off. Then ...
Fixes & Summaries for Ford
|1995 Ford F-350 Special 7.5L clutch pedal VIN: 1FDKF38G2R
Thanks to the helpful info. from all. It was just as everyone had stated this system is just hard to bleed. After many attempts. We held the vacuum brake bleeder tight to the slave cylinder and let it do its job. it was hard to hold in place since this slave c...
|1998 Ford Windstar 3.0L 3.0L GEM Module VIN: 2FMZA51U9W
I tryed what you all siad . To wait it out. That is really good info. However the draw would never go away. A new Gem Mondule was put in and then the draw went away after 45 minutes or so like you all siad. Thanks for the great info once again. Steve
|1999 Ford Windstar SE 3.8L MIL Lamp on VIN: 2FMZA5245X
Thanks to all that responded to our project. We did get the vehicle back in to check baro a few weeks ago and it was in fact showing approx 28. We cleared the computer just to see if it might reset itself. It did! to 27.1. (MAF is clean, all circuitry is in ... Trouble codes: P0171 (02 lean bank 1), P0174 (02 lean bank 2).