Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for September 8, 2004
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1999 Dodge Durango SLT 5.2L Surge, Stall VIN: 1B4HS28Y6X
Hello Everyone, I hope someone can give some insight into this one. The vehicle came in knocking, it had spun bearings on the crank, but would idle normally. The vehicle was driven in with the only complaint: engine knock. The engine was changed with a low mil...
View
2000 Dodge Ram 2500 Truck 5.9L Mechanical VIN: 3B7KF2368Y
Truck came in for a fluid leak from a cracked trans case and tranfer case adapter. Recased trans with new bearings and blocker rings. Now it works fine until you shift into 5th gear. Then you have to put it in reverse before it will go into any other gear. Wha...
View
2001 Dodge Stratus SE 2.4L Suspension VIN: 1B3EJ46X41
Have this stratus with a loud popping noise on acceloration and stopping. We have checked under car for anything loose. I also found a TSB on the front sway bar bushings, so we removed the sway bar and it did not effect the noise. You can get in the car in the...
View
1993 Plymouth Sundance 2.5L Brake pedal VIN: 1P3XP28D3P
Customer came in complaining of the brake pedal going to the floor occasionally,and then would pump back up again and work fine.Cust noted excessive travel under heavy pedal pressure at this time too.Cust requested new master cylinder (and we agreed),as no lea...
View
1995 Plymouth Neon Sport 2.0L hoses VIN: 3P3ES67C1S
this car runs a bit off, but that seems to be more of a fuel issue. Never gets hot, doesnt steam or piss coolant. After driving long enough to reach full temp, upon shut off car will burble back to coolant resivior, but not enought to flow over. just curious i...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
1993 Chrysler LeBaron LX 3.0L tcm VIN: 1C3XU5535P
thanks to Randy from Pennsylvania for pointing me in the right direction - he indicated that low system voltage was likely the culprit. monitoring the battery feed circuit to the relay, key off, i found 12.4 volts - then i leaned on the fender and voltage drop...
5
1997 Jeep Grand Cherokee Laredo 4.0L abs module VIN: 1J4GZ58S9V
customer wants to change abs module but not right now. will post results when module is changed. thank joe
2
2001 Jeep Grand Cherokee Limited 4.0L Starting VIN: 1DTRYTHGF1
Thanks to all techs who assisted me on this one. It was very simple- The cable just needed a hair of adjustment to make it go into park. Now all is fixed, thanks again.
10
1998 Plymouth Voyager 3.0L surpentine ( drive belt ) VIN: 2P4FP2531W
thanks to all you chrysler guys , i move the ps pulley in about 3/16 and installed a new gator back belt from goodyear and the belt looks good when you eye ball it to the tentioner pulley thanks agian mark
25
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next