|Prev||Professional Automotive Repair Technical Discussions for August 22, 2004
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|1986 Toyota Pickup 2.4L Engine Noise VIN: JT4RN55D5C
hey guys this is acually one of my personal vehicles. this truck has an erratic ticking sound when at no load or on decel. it does not have the noise while idling. only if i bring it above idle and hold it there. im thinkin it the timing chain beating on the f...
|1992 Toyota Camry DLX 2.2L Stall VIN: 4T1SK11E5N
vehicle came in with no spark, after replacing condenser & ign coil it will start but no idle, runs rough and dies.i've checked every sensor on this vehicle + belt timing, compression, computor pin test,injector signal irratic, found igt (igniter) signal at co...
Fixes & Summaries for Asian
|2000 Honda Civic LX 1.6L MIL Lamp on VIN: 1HGEJ6574Y
thank for you e mail it cause me to recheck all the basics fuel pressure map , tps , cts, and so on after a few hours later while scanning , I unplugged o2 sensor 1 and the scanner said no reading on Sensor # 2 Bingo . The tech that installed cat-manifold asse... Trouble codes: P0133, P0420 (Catalyst System Below Threshold).
|2002 Nissan Altima 2.5L No Start VIN: 1N4AL11D82
Thanks to Steve from New York. Steve gave me the tsb. #. Customer took it to the dealer and I did not get to find out what they did.
|2002 Nissan Sentra CA 1.8L Hesitation VIN: 3N1CB51A82
I checked everything i could again, including MAF, and mechanical,(timing marks lined up)I believe the exhaust was still plugged, possible in the secondary cat and or muffler. The customer deceided to drive car like it is. Thank you everyone.
|1993 Toyota Corolla 1.6L MIL Lamp on
I want to thank you guys for clearing things up. I have not worked on to many imports as you might have guessed. The car just needed the O2 sensor replaced. AllData did in fact show the brown wire as a ground. I found the same information on the web that had... Trouble codes: 21 (Oxygen Sensor Signal).