|Prev||Professional Automotive Repair Technical Discussions for August 14, 2004
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1998 Dodge Ram 1500 Truck 5.2L MIL Lamp on VIN: 1B7HF16Y7W
Hello all. Scanner shows 1-3 volts on rear oxygen sensor at operating temp. Reading does fluctuate,but stays too high. If I unplug rear sensor, KOER and KOEO shows about 5 volts. Hooked DVOM to sensor signal wire, (harness side, sensor unplugged) averages abou... Trouble codes: P0138 (Downstream O2 sensor shorted to voltage)
|2000 Dodge Grand Caravan 3.3L Stall VIN: 2B4GP24R5Y
Hello, The IATN is the best thing since sliced bread! It has been a lifesaver. Keep up the good work. This van is wining. We thought we had it fixed. Van stalls after first 20-30 minutes of driving. Most of the time it is on a turn, however has done it on hill...
Fixes & Summaries for Chrysler
|2002 Dodge Grand Caravan Sport 3.3L brake pedal
Thanks for all the response. I was stumped by the nature of the brake vibration. The surface that the brake lathe's cone rides on had surface rust. A surface prep pad now sits next to the lathe. All mating surfaces are clean of any rust or dirt from here out. ...
|1997 Jeep Grand Cherokee Limited 5.2L Hesitation, Stall VIN: 1J4GZ78Y1V
Replacing the PCM took care of the losing fire problem. But I still had a slight stall on heavy acceleration. Replaced the fuel pump and solved the remaining stall problem. Alldata states that 1/4 liter(approx. 4oz.) of gas in 7 seconds is acceptable volumn bu...