|Prev||Professional Automotive Repair Technical Discussions for August 7, 2004
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for European
|1977 Porsche 911 S 2.7L Poor Idle Quality, Stall VIN: 9117210653
This car does not idle well. Admittedly I know very little about Porsches. Just sitting in the shop it does not idle too badly. The customer says when the engine temp reaches about 200 degrees it begins stalling. And since it is a manual tranny it is nearly im...
|1990 Volkswagen Fox 1.8L No Start, Cuts out VIN: 98WGA2302L
car towed in dead. Started and ran to drive in bay. car ran for about 45 minutes and died. fuel pressure checked at cold start valve reads 85-90 lbs when car is running well, drops to 40-45 lbs when car dies. close off fuel gauge return line and pressure rises...
Fixes & Summaries for European
|1999 Audi A4 1.8L Poor Idle Quality, Misfire VIN: WAUCB28D2X
Thanks to ten people who took time to reply: Alex [...].It was the power stage or end stage and everyone had the same response; the end stage.Than...
|1993 BMW 325i 2.5L Electric windows VIN: WBACB3315P
Thanks for the help. The cutout switch is to the right of the steering column. One wire was pulled off. After reattaching the wire the windows worked for about 30 seconds and then quit. The comfort relay went bad. ??? Replaced the relay, and all is good. T...