|Prev||Professional Automotive Repair Technical Discussions for June 12, 2004
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1991 Ford LTD Crown Victoria LX 5.0L srs VIN: 2FACP74F6M
code 5 flashing , checked sensor ohms , jumped driver air bag and still got code 5 , short version ran all the steps in the mitchell trouble tree and it passed all steps where should i look next ? Thanks
|1997 Ford F-150 XL 4.2L Excessive Emissions, Poor Idle Quality, Stall VIN: 1FTDX1722V
vehicle starts but has no power. it backfires and seems to be burning lean. manifolds and cats heat up to a cherry red color in about 2 minutes. pulse widths are running about 16 m.s. and the spark advance is going as high as 16,250. no code information shown ... Trouble codes: 1507 (idle air control under speed error)
|1999 Lincoln Continental 4.6L Misfire VIN: 1LNHM97V9X
this vehicle does a little buck or surge at slow speed going uphill just before the transmission wants to shift as soon as shifts does not do it anymore have tried swapping 2 new coils in to system in all position stays the same runs fine when driving at norma...
|1997 Mercury Villager (Van) GS 3.0L rear blower motor VIN: 4M2DV1115V
I can't seem to find the REAR blower motor relay and or the REAR blower motor switch relay. I have ALLDATA and On demand and they both list serveal places for them to be and they are no where to be found...I have looked over the drivers side tire inside above ...
Fixes & Summaries for Ford
|1990 Ford F-250 Custom 7.3L upshifts VIN: 1FTHX25M9L
Thanks to all. Many helpful replies. Ultimately we experimented with the FIPL. The truck came in w/1.2v. I believe that is spec. To see if we could improve the shifts, we misadjusted the voltage to .8v. That made for very early shifts and set a code (no MIL) o...
|2000 Lincoln LS 3.0L Cylinder heads
Well I got no responses on this one but still managed to get it done. It is not finished yet, the customer had a aftermarket warranty and the company sent by a rep to check and see what caused his overheating and misfire. Well the multilayered gasket showed no...