|Prev||Professional Automotive Repair Technical Discussions for June 4, 2004
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1997 Jeep Grand Cherokee Laredo 4.0L fuel VIN: 1J4FX58VC6
Hello Techs, this Grand Cherokee is back in my shop again.With same problem. No fuel Delivery, no spark. I have replaced pcm, cps.But still only cranks, no start. I have 5volts on the red-black wire & also at black =white wire at cps terminal. Am I supposed to...
|1999 Chrysler Cirrus LXi 2.5L MIL Lamp on VIN: 1C3EJ56H6X
This is a 1999 Chrys. Cirrus with a 2.5l engine. Mil lamp on with code p0442. I can't get any concrete info from All-data. Can someone please point me in the right direction. There is a valve near the gas tank and all 3 terminals read 13.8 volts at idle when I... Trouble codes: P0442 (evap medium leak)
|2002 Chrysler Sebring LX 2.7L ignition VIN: 1C3EL46R92
im having a big problem with this chrysler, is blowing the #8 and #23 fuse in the power distribution center. i have replaced the starter, took apart the ignition switch, removed all the relayes on that circit and it still shorted. it started a couple of times ...
|1998 Dodge Caravan 3.0L Poor Idle Quality, Misfire VIN: 2B4FP2530W
Had a P0306 before any repairs. After repairs code does not return. Ater engine is hot idles very rough in gear. Did motor vac. Fuel trim when acting up goes from -3% to .6%. Cylinder balance test is even. Check for vacuum leaks with smoke machine (egr was lea...
|2000 Jeep Wrangler Sport 4.0L MIL Lamp on VIN: 1J4FA49S5Y
Hi guys, This vehicle came in yesterday with mil light on. Pulled codes and found po123 set. Replaced TPS and code will not clear. Scan data shows TPS at 5.0 volts all the time. Perform circuit test and found 5.7 volts on orange/blue wire all the time.I though... Trouble codes: P0123
Fixes & Summaries for Chrysler
|1969 American Motors AMX 6.4L tach VIN: A9M397X126
the tach has two wires coming from it. blue and yellow. the blue wire comes from the starter sylonoid to the tach with the yellow one going to the old coil. the tach feeds the old coil 10.5 volts and gits its signal from this wire some how. we tried hooking th...
|1998 Chrysler Town & Country (Van) LXi 3.8L starter VIN: 1C4GT64L7W
Thanks for the replies, but I did not fix the van. Replies suggested it could be a BCM problem. One person had trouble with BCM's for lighting problems. Another suggested a possible ground problem. The 3rd person had problems with the ignition switch. All logi...
|1996 Dodge Ram 1500 Truck 5.2L Excessive Emissions, Hesitation
well this one is fixed and out the door,i went back to basics.even though i checked the cat converter i was not happy with the results,so i hooked up my scanner and went on a road test and i watched the map vacumn when i stomped down on the gas the car was los...
|2001 Dodge Ram 3500 Truck 5.9L power steering VIN: 1B7MF33771
Thanks for the replies. I'm not sure if I made it clear, but it was actually the drive on the vacuum pump that drives the PS pump that broke, not the flange. I received an interesting reply from a tech at a Dodge dealership stating that unless it is improperly...
|1998 Plymouth Grand Voyager Expresso 3.3L headlights,parking lamps, dash lights VIN: 1P4GP44G8W
REcieved two replies. since the scan tool indicated the lights where on. and the lights on chime would work when the key was removed. we had no ground signal from the BCM at the relays and all lights where lost at the same time. we replaced the BCM and all is ...