P0150 Diagnostic Trouble Code Discussion for January 2010
Air Fuel Sensor (Bank 2 Sensor 1) Closed Loop Performance
Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.Trouble Ticket Help Requests for DTC P0150
| Help Request | Posted | |
| 1995 Nissan Maxima SE 3.0L No Start, Poor Idle Quality VIN: JN1CA21D5S P0150: Left front heated O2 Sensor fault. ... hard starting when warm, It starts like it is flooded or very rich. Otherwise it runs well once you get it started. This all only happens if you get the car HOT and then shut it off and wait approx 10 min. If you try to start it right after you shut it of... |
January 18, 2010 | |
| 1995 Nissan Maxima SE 3.0L No Start, Poor Idle Quality VIN: JN1CA21D5S P0150: Left front heated O2 Sensor fault. ... hard starting when warm, It starts like it is flooded or very rich. Otherwise it runs well once you get it started. This all only happens if you get the car HOT and then shut it off and wait approx 10 min. If you try to start it right after you shut it of... |
January 21, 2010 | |
| 1996 Nissan 300ZX 2 2 3.0L MIL Lamp on VIN: JN1RZ26D97 P0150: Heated Oxygen Sensor (Bank 2 Sensor 1) Closed Loop Fuel Control. need a nissan guru for this one. last week i did about 30 hours of work to this 300zx and everything went well until the test drive. it popped the ses lamp on for a b2s1 o2 fault. upon checking pids i found the b2s1 was stuck at 30-40 mv and the b1s1 was stuck... |
January 25, 2010 | |
| 2006 Nissan Maxima SE 3.5L MIL Lamp on VIN: 1N4BA41E86 P0150: Air Fuel Sensor (Bank 2 Sensor 1) Closed Loop Performance. ... years. retrieved code p2a03- o2 sensor range/ performance. found fuse number 15 in underdash fuse panel had been removed. installed new fuse. cleared cel. cel came back on with p0420- cat efficency. inspected cats with boros... |
January 28, 2010 | |
| 2006 Nissan Maxima SE 3.5L MIL Lamp on VIN: 1N4BA41E86 P0150: Air Fuel Sensor (Bank 2 Sensor 1) Closed Loop Performance. ... years. retrieved code p2a03- o2 sensor range/ performance. found fuse number 15 in underdash fuse panel had been removed. installed new fuse. cleared cel. cel came back on with p0420- cat efficency. inspected cats with boros... |
January 29, 2010 |
