 Prev |
Professional Automotive Repair Technical Discussions for September 17, 2025 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for All Makes and Models
| Help Request | Answers | |
| 2020 Acura MDX SH-AWD 3.5L Safety VIN: 5J8YE1H40S First off this MDX is a 2025, the form does not offer a 2025 selection, car came to us from a body shop that we do the electronics for, slight hit in the front, a new right front corner parking sensor, the Parking Sensor Switch to the left of the steering ... |
View | |
| 2005 Chevrolet Silverado 1500 5.3L compressor VIN: 1GCEK19Z75 AC runs fine = properly cold. Then out of clear blue sky comes a hissing from compressor and refrigerant blowout. Has a hard code for re-circulation actuator in the cabin system. Monitoring high pressure sensor with scanner need goes into 400s. Monito... |
View | |
| 2015 Ford Focus SE 2.0L No Start VIN: 1FADP3K22F Customer was low on gas and added roughly 1/4 tank of diesel by mistake. Customer then drove an unknown number of miles (less than 100) on diesel until it started to run bad. Vehicle was then towed in. Here is what I have done so far: 1. Removed the fuel t... |
View | |
| 2019 Ford Escape SEL 1.5L MIL Lamp on VIN: 1FMCU9GD4K I thank you very much any tech who offers help on this Escape! This Escape came to our shop with a code P04F0 "EVAP System High Load Purge Line A Performance". It has been previously to a shop where they replaced the vacuum harness and all the associa... Trouble codes: P04F0 |
View | |
| 2020 Ford F-150 XLT 3.5L Door locks VIN: 1FTEW1E45L By mistake I set my admin key to MyKey. After this occurred, I found that my fob would not lock or unlock the doors. I tired to learn the fobs by unlocking drivers door and cycling key on off 10 times, but the truck will not go into learn mode. I use IDS t... |
View | |
| 2013 GMC Sierra 2500 HD SLE 6.0L Engine VIN: 1GT12ZCG2D Supposedly an easy straightforward fix especially an overheating issue. Not this one, its kicking my behind big time. I spent hours and hours of diagnosing the issue and fired the parts cannon multiple times and still no fix! This is a 13 GMC SIERRA 2500HD... |
View | |
| 2021 Jeep Wrangler Unlimited Sahara 2.0L Hybrid System VIN: 1C4JJXP64N Dear members, I have this 2022 Jeep Wrangler 4Xe hybrid, the car will not start, it was showing fault code for electric coolant Battery heater, I replaced it with a new one but now I have P0AA1-00 Hybrid Battery Positive Contactor Circuit Stuck Closed. Any... |
View | |
| 2015 Ram 3500 SLT 6.4L abs VIN: 3C7WRSBJ2F Looing for a little help. Working a ram3500. We just did the evap core and heater core assy. Dash removal. Veh road test and then traction control and check eng lite came on. Ran test and pulled code c0042 at first. Found the bpp had come apart. Install an... |
View | |
| 2012 Volkswagen Passat TDI SE 2.0L Stall VIN: 1VWBN7A38C Car was towed in that it wouldnt start and would not move at times. It started just fine but when you put it in gear, and you start to roll it will stall. If you keep the rpm up it might stay running and let you move it but it has no real power. Checked fu... Trouble codes: P26A0, P1010, P1110 |
View |
Fixes & Summaries for All Makes and Models
| Fix/Summary | Answers | |
| 2009 Audi S5 4.2L MIL Lamp on VIN: WAURV78T79 The vehicle has electronic position motors. the bank 2 position sensor is out of scale: the engine is a used unit, so not sure if the plenum came with the replacement unit, and or any mechanical linkage is bent -damaged. when vehicle is started both motors eng... Trouble codes: P2019 (Intake riunner position sensor circuiot bank 2). |
3 | |
| 2010 Nissan Murano LE 3.5L Brake Pedal VIN: JN8AZ1MW7A Well it ended up being the ABS controller just like the TSB said. The good news for the customer is I got the dealer to cover it for them. They said as long as it hadnt been performed they would do it so lucky for the customer this time. Thanks to Michael for ... |
13 |
