 Prev |
Professional Automotive Repair Technical Discussions for July 22, 2025 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for All Makes and Models
| Help Request | Answers | |
| 2017 Jaguar F-Pace Premium 2.0L MIL Lamp on VIN: SADCK2BNXH Would like to know where this sensor is and how to diagnose it Trouble codes: P24C6 |
View | |
| 2020 Kia Soul LX 2.0L Compressor VIN: KNDJ23AU9L I have a 2020 Kia Soul Vin: [...] with the 2.0L engine and MANUAL a/c. The compressor is not being commanded on by the PCM. I used Autel, Snap-On and even bought a subscription to factory Kia scan tool with j-box. There are no DTCs in any modul... |
View | |
| 2012 Mitsubishi Lancer SE 2.4L ABS wheel senaor VIN: JA32V2FW9C After replacing the LF wheel bearing and sensor the ABS light and trac light came on after approx 4km of driving. Looking a data it show the LF wheel speed is almost double the other 3 wheels. Thinking is had to be a tone ring issue we replace bearing agai... |
View | |
| 2014 Volkswagen Jetta SE 1.8L oil pressure VIN: 3VWD17AJ4E This Jetta has a slight rattle coming from the top of the engine and red oil pressure light on. I removed oil pressure sensors and tested oil pressure with mechanical gauge and oil pressure was5 at idle and 12 at 2000 rpm which is extremely low. I removed ... |
View | |
| 2006 Volvo V70 2.4 2.4L 3-2 down shift VIN: YV1SW61216 Hello everyone, This car came to me from a transmission shop. They had rebuilt the automatic trans once. Replaced the valve body 2 additional times. I do not know what brand parts were used or to the extent of the rebuild. It was at the transmission sho... |
View |
Fixes & Summaries for All Makes and Models
| Fix/Summary | Answers | |
| 2011 Mercedes-Benz E350 4Matic 3.5L radiator fan VIN: WDDHF8HB6B as mark says pretty simple..what makes it hard is when the line from ecm to m4/7 is open circuit..andrew made me look more carefully as to what wiring i should be following..it ended up being pin 43 at ECM and pin 4 at M4/7..i then put an overlay from 43 to 4 ... |
6 |
