 Prev |
Professional Automotive Repair Technical Discussions for August 29, 2024 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for All Makes and Models
| Help Request | Answers | |
| 2018 Chevrolet Trax Premier 1.4L Brake Pedal Position Sensor VIN: 3GNCJPSBXJ I have a no start on this Chevy Trax. When brought in the BPPS was reading .5 VDC and would not change when the pedal was actuated. R&R with GM provided BPPS. Now the pedal changes the voltage based on position. I tried to re calibrate using a Launch scan ... |
View | |
| 2008 Ford Fusion SEL 3.0L charging system VIN: 3FAHP08188 customer drove the car in, said he replaced the battery, and it continued to go dead. we boosted it off and drove it into the shop. upon inspection, we found the battery completely discharged. charged and tested, good reconnected battery, and started... |
View | |
| 2018 Lincoln MKX Black Label 2.7L MIL Lamp on Have had some difficulty accessing information on this one. Performed tests listed in Identifix yielding no obvious defects. Pulled Purge and Tested with Power Probe and Vacuum and the Assembly behaves normally. Hoping someone out there has run into this. ... Trouble codes: P014C |
View |
Fixes & Summaries for All Makes and Models
| Fix/Summary | Answers | |
| 2007 Dodge Caliber R/T 2.4L communication VIN: 1B3HE78K77 Thanks for the replies. I have tried load testing all the wiring from the transmission to the TCM and all the CAN lines connected to the transmission, PCM, 4 wheel drive module, and the abs, and through the TIPM, with no wiring found to be bad. I did locate al... |
5 | |
| 2015 Ford Explorer Limited 3.5L No Start VIN: 1FM5K8B89F We started by disconnecting the wire harness that goes to the top of the tank and found the plug melted around the one terminal. the female side of the terminal was twisted so it did not contact the male side properly. We spliced a piece of wire to the one sid... |
8 |
