 Prev |
Professional Automotive Repair Technical Discussions for October 17, 2020 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for All Makes and Models
| Help Request | Answers | |
| 2016 Chevrolet Malibu LT 1.5L BCM Program VIN: 1G1ZE5ST2G One for you GM programmer guys. Replaced the BCM in this '16 Malibu LT because rear turn signals not working. Read up on programming procedure in Mitchell before installing. Mitchell states leave the push button in off position as SPS will control it while... |
View | |
| 1997 Ford F-250 Lariat 5.4L Parking brake cable VIN: 2FTFF27L1V 97 F250 XL 5.4, disk/drum. Replaced rear shoes, cylinders and drums. I cannot install the main adjuster lever as the bottom lug contacts the front brake shoe. I can move the shoe forward slightly and then I can install the lever but, the front shoe ... |
View | |
| 2011 Ford F-350 Super Duty King Ranch 6.7L No Start VIN: 1FT8W3BT8B had codes for pcm, low fuel pressure, replaced fuel injectors, fuel pressure still 389 psi, replaced high pressure pump, still at 389, replaced pressure regulator, no change, replaced pcm because of codes, injector #8 has - [...] for fuel balancing rate... |
View | |
| 2009 Mercedes-Benz C63 AMG 6.3L No Start VIN: WDDGF77X49 Hi guys, got this w204 with the infamous steering lock problem, I was thinking of replacing just the motor inside the esl unit but my question is: would it still need to be coded?, and if so could it be done with maxisys ms908? Also what is your experience... Trouble codes: A2546 |
View |
Fixes & Summaries for All Makes and Models
| Fix/Summary | Answers | |
| 2017 Jeep Renegade Latitude 2.4L Poor Idle Quality, Hesitation, Misfire, MIL Lamp on VIN: ZACCJABB5H sorry for took to long to close this one yes was one tooth of at camshaft the tech who work on it was using prodemand for timing reference and yes prodemand is wrong on this one thank you for your help Trouble codes: P0016 (Crankshaft/camshaft timing misalignment bank 1 sensor 1). |
4 |
