 Prev |
Professional Automotive Repair Technical Discussions for January 14, 2018 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for All Makes and Models
| Help Request | Answers | |
| 2002 Chrysler PT Cruiser Dream 2.4L engine balance VIN: 3C8FY68B22 Installed reman and it seems like the engine was never in balance. Rechecked timing several times to verify marks & went thru the eng mt setup procedures on initial install. Timing at crank mark is trailing edge of gear and at cams the 2 marks line up. Current... |
View | |
| 2008 Ford Focus S 2.0L communication canbus Hi Guys, I need a bit of help with this Ford Focus.Vehicle got towed to workshop no start,no crank and no communication.I have no communication with engine,immobilizer,steering,abs & instrument cluster modules.I do have communication with air bag & bcm.... |
View | |
| 2011 GMC Sierra 2500 HD SLE 6.0L MIL Lamp on VIN: 1GT22ZCG9B Getting Stumped on this one, truck came in with code for rear O2, we diagnosed and replaced, scan tool readings were maxed out at 1.275mv, bias voltage is 1.9V going to sensor and had 1.2 - 1.25 returning back on Low Sig wire. It came back a week later wit... Trouble codes: P0138, P0158 |
View | |
| 2003 Mercury Sable LS Premium 3.0L Oil Separator VIN: 1MEHM55S13 We are repairing a motor oil leak that is coming from the oil separator that is located between the cylinder heads. Mitchel says to remove the cylinder head to replace. My question is there any way of sneaking it out with removing the head. |
View | |
| 1991 Toyota Pickup DLX 3.0L Cam pulley VIN: JT4VN13D0M After replacing the head gaskets and starting it up the cam pulleys are rubbing against the inner timing belt shield. Are there thinner cam seal retainers or pulley shims. Not sure what to do. It sounds terrible. |
View | |
| 2002 Volkswagen Jetta TDI 1.9L Excessive Emissions, Poor Idle Quality, Surge, Misfire VIN: 3VWSP69M82 This vehicle arrived with the turbocharger bearings failed and intercooler filled with engine oil. Customer said the battery was weak, but I'm suspicious it hydrolocked based on his description. It started and ran when it arrived but, due to the turbocharg... Trouble codes: P0302 (Cylinder 2 misfire) |
View |
Fixes & Summaries for All Makes and Models
| Fix/Summary | Answers | |
| 2007 Volkswagen Jetta Wolfsburg Edition 2.5L MIL Lamp on VIN: 3VWEG71K87 Thank you all that took the time to reply. It was the magnetic tone ring on the crank shaft. You can see this by removing the rpm/crank sensor. I inspected the magnetic lines on the ring with some metal shavings...sure enough there was a dead spot on the r... Trouble codes: P0300, P0301. |
12 |
