P0016 Diagnostic Trouble Code Discussion for December 2017
Crankshaft/Camshaft Timing Misalignment
Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.Trouble Ticket Help Requests for DTC P0016
| Help Request | Posted | |
| 2010 Chevrolet Traverse LT 3.6L Poor Idle Quality VIN: 1GNLVGED0A Found slack at the rear bank on the timing chains. replaced all of the chains. Started the traverse back up and same codes. Updated pcm/tcm. same codes. removed engine again, rotated the engine about a million times until the marks lined up again. Everythi... |
December 13, 2017 | |
| 2009 Mazda CX-7 Touring 2.3L MIL Lamp on VIN: JM3ER29L59 P0016: Cmp/Ckp sensor correlation. ... together, it would only fire on one or two cylinders and not start. Checked fix database and realized the plastic cam holder I used did not keep cams properly aligned. Did the timing process over and this time used metal tool. Double checked and all se... |
December 13, 2017 | |
| 2009 Dodge Grand Caravan SXT 4.0L No Start, Surge, Stall VIN: 2D8HN54X79 P0016: Cam/crank sync. Problem. This van stalls like the key is switched off. Idling it will run smooth until warm then die. It will usually start after engine is cool, but not always. We tried starting on brake cleaner through air tube while cranking but it didn't even try. Erased codes... |
December 14, 2017 | |
| 2007 Volkswagen Jetta 2.0T 2.0L MIL Lamp on VIN: 3VWAJ71K27 P0016: Cam/crank correlation fault. ... to keep is short as possible. Banging my head on this one. Car originally came in for mil light for fault with fuel pressure code- we found the intake camshaft lobes worn off (typical issue for this car) we replaced the intake cam-fuel pump-timing belt... |
December 14, 2017 | |
| 2009 Dodge Grand Caravan SXT 4.0L No Start, Surge, Stall VIN: 2D8HN54X79 P0016: Cam/crank sync. Problem. This van stalls like the key is switched off. Idling it will run smooth until warm then die. It will usually start after engine is cool, but not always. We tried starting on brake cleaner through air tube while cranking but it didn't even try. Erased codes... |
December 15, 2017 |
