 Prev |
Professional Automotive Repair Technical Discussions for October 15, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for All Makes and Models
| Help Request | Answers | |
| 2012 Audi S5 4.2L timing chain VIN: WAUVVAFR8C hello everyone,I have this real nice well maintained 2012 S5 with 73,000 miles in the shop.the customer would like to replace the timing chain and rails as a maintenance item. there is currently nothing wrong anywhere with the chain,he is just concerned about... |
View | |
| 2002 BMW 745Li 4.4L No Start VIN: WBAGN63422 Thanks in advance for the help.Car came in for a no-start. Diagnosed and replaced bad fuel pump, replaced & registered new battery. After the second test drive, car stalled & wouldn't restart, cranks fine. On my snap-on scanner it reads immobilizer enabled-yes... |
View | |
| 2003 Dodge Ram 1500 Laramie 5.7L Misfire VIN: 1D7HU18D23 Misfire p0300 needed full tune up,before and after when starting feels like timing is advanced hard crank, was advanced.i used a scope cam and crnk i dont know if the timing is off ,have no wave form in iatn on hemi 2003. Any one can send me a wave form on thi... Trouble codes: P0300 (Multi misfire) |
View | |
| 2008 Dodge Caliber SE 2.0L MIL Lamp on VIN: 1B3H628BX8 followed diag flow chart twice end result replace valve- no diff. I have 1.02v at idle on the flow valve signal line, and 4.5v when commanded on. Used scope for waveform, looks almost perfectly squared when computer does self check at start up. a very slight s... Trouble codes: P2015 |
View |
Fixes & Summaries for All Makes and Models
| Fix/Summary | Answers | |
| 2008 Smart Fortwo Pure 1.0L MIL Lamp on VIN: WMEEJ31X78 My problem was the wiring diagram colors didn't match the connector on this map sensor, and found 12 volts at sensor connector. After finding the colors did match the diagram at the pcm, and this had recently had a engine swap, I started looking for connectors... Trouble codes: P0108. |
5 |
