P0302 Diagnostic Trouble Code Discussion for June 2017
Cylinder 2 Misfire Detected
Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.Trouble Ticket Help Requests for DTC P0302
| Help Request | Posted | |
| 2000 Audi TT 1.8L Misfire VIN: TRUUC28N7Y P0302: testing and results. Hi all in IATN land. Thanks so much for reading this post. As you can see from the info this car was a mess when it came in. It runs great at cruise and even when you get on it. If you drive it for 20 min and lug it down at 2000 rpm in 5th gear it will misfire... |
June 06, 2017 | |
| 2012 Honda Odyssey LX 3.5L Misfire, MIL Lamp on VIN: 5FNRL5H64C P0302: cyl. 2 misfire. Customer was in 6 months ago p0303, plug was full of oily carbon build up, sent to dealer to have piston ring recall done, was fine till now. came in with misfire cylinder 1-3 misfires. R&R plugs they are clean, smoke test no leaks found. Road test vehicle... |
June 06, 2017 | |
| 2012 Lotus Evora S 3.5L Hesitation, Surge, Stall VIN: SCCLMDSU3C P0302: Misfire fault stored Cleared faults sympoms returned without flagging misfire faults again. The symptoms for the concern are as follows- After the car warms up fully, the engine will hesitate under nearly any load, but will only do so intermittently. The sensation is that the accelerator pedal is not being pressed. It's most noticeable under heavy lo... |
June 14, 2017 | |
| 2006 Toyota Sienna LE 3.3L Misfire VIN: 5TDZA23C36 P0302: Cylinder 2 Misfire Detected. ... (P0300, P0302, P0304 and P0306) stored in the engine computer. Cleared the codes and test drove and did not verify the issue. Changed the spark plugs because they were due for maintenance. Cam... |
June 15, 2017 | |
| 2005 Hyundai Accent GLS 1.6L MIL Lamp on VIN: KMHCG35C35 P0302: Cylinder 2 Misfire Detected. ... p0300 p0302 p0303 p0304 and his hard to starts but only one time every 2 months the car is well maintened by us new plug new eom wire .my question is is it possible that the crank sensor gave a bad signal sometime, or is it... |
June 26, 2017 |
