P0011 Diagnostic Trouble Code Discussion for May 2016
Camshaft 1 Position Sensor Target Performance (Bank 1 Sensor 1)
Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.Trouble Ticket Help Requests for DTC P0011
| Help Request | Posted | |
| 2007 GMC Sierra 1500 SLE 6.0L MIL Lamp on VIN: 3GTEK13Y87 P0011: Intake Camshaft Position System Performance. ... especially the bold part. After 400 miles of driving the codes that have returned are P0011 intake cam perf. And C0561-ABS code;sys disabled ifno stored-invalid serial data. On March 30th customer brought vehicle to me from dealer with intermittant compla... |
May 07, 2016 | |
| 2010 GMC Sierra 1500 SLE 5.3L MIL Lamp on VIN: 3GTRKVE3XA P0011: camshaft actuator. I had a oil pressure issue causing lifter on #6 cylinder to clatter found lifter bore damaged causing oil pressure loss I installed reman jasper engine now I have this code in the stall I can command cam timing and it will respond but on the highway desired an... |
May 12, 2016 | |
| 2008 Saturn Aura XE 3.5L Poor Idle Quality, Hesitation, Stall, MIL Lamp on VIN: 1G8ZS57N98 P0011: Camshaft position performance. ... Aura. The vehicle currently runs rough at idle. I have not yet attempted to drive the vehicle as I don't want to be the "Lucky One" the motor locks up on if indeed the chain is stretched. According to dozens of forums I have read there is a compute... |
May 26, 2016 | |
| 2008 Saturn Aura XE 3.5L Poor Idle Quality, Hesitation, Stall, MIL Lamp on VIN: 1G8ZS57N98 P0011: Camshaft position performance. ... Aura. The vehicle currently runs rough at idle. I have not yet attempted to drive the vehicle as I don't want to be the "Lucky One" the motor locks up on if indeed the chain is stretched. According to dozens of forums I have read there is a compute... |
May 27, 2016 | |
| 2008 Chevrolet Malibu Classic LS 3.5L Poor Idle Quality, Hesitation, Stall, MIL Lamp on VIN: 1G1ZG57N08 P0011: Camshaft A Position. ... The customer stated that the oil was low and they added two quarts roughly. As I commented above in the repair history, I have changed the oil and filter with the correct viscosity oil 5W-30 and cleared the codes. P0016 came back almost immediately. The c... |
May 30, 2016 | |
| 2009 Infiniti G37 X 3.7L No Start VIN: JNKCV61F79 P0011: Intake Valve Timing control. This car came in with a P0340 bank 1 cam sensor.No start. Unplug sensor and would run but not rev up. (fail safe mode). Customer had already replaced sensors with Rock auto sensors which I presumed was not OE. Ordered OE sensors and installed and same problem.... |
May 30, 2016 |
