 Prev |
Professional Automotive Repair Technical Discussions for February 15, 2015 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for All Makes and Models
| Help Request | Answers | |
| 2003 Cadillac CTS 3.2L Poor Idle Quality, Surge, MIL Lamp on VIN: 1G6DM57N53 Hello Caddie tech's, we replaced the intake manifold gaskets for a missfire on bank one, 1,3 and 5. That fixed the miss, but this car was started without the throttle body hooked up. So now we are having a problem with getting this to relearn. Did the procedur... Trouble codes: P2176 (Min t/p not learned) |
View | |
| 1995 Chevrolet K1500 Cheyenne 5.7L Misfire VIN: 1GCEK19K3S Having problems on this Chevy truck. Seems to be a misfire on cylinder 5. Has spark. That plug looked like a lean run compared to the rest on that bank. Compression does seem low, but it is even. I need some suggestions on where to go from here. Unplugged... |
View | |
| 2003 Chevrolet Tracker 2.0L temp guage VIN: 2CNBJ18C93 no temp reading on gauge, fuel gauge reads fine, all other gauges read well, ecu shows proper engine temp, vehicle runs well, no other systems affected, send instrument cluster out for repair, was sent back saying internal damage, can not be repaired, engine h... |
View | |
| 2003 Ford Expedition XLT 5.4L instrument cluster, dome lights, door locks VIN: 1FMFU16L23 Gauge needles bounce on cluster and indicator lights for cluster flash, dome light dims/pulses, door locks lock and unlock, if window switch is held down when problem occurs it will stop and go with pulsing of all other problems. All pulsing is with key off on... |
View | |
| 2010 Ford Fusion SE 2.5L no crank vehicle will not crank to start if you jump a relay on ground terminal going to the PCM the engine wont crank and start |
View | |
| 2002 GMC Sonoma SL 4.3L No day time running lights or lowbeam VIN: 1GTCT19WX2 I have this Gmc Sonoma in My bay,with no day time running lights or low beam.There is the w/zr2(which I believe is what I have)However the wiring diagram for the w/zr2 shows the day time running lights relay taped to the bodyhardness near breakout for rear was... |
View | |
| 2006 Mercedes-Benz CLS500 5.0L No communication VIN: WDDDJ75XX6 Car came in on flat bad after one strut exploding the left strut . Replaced strut and compressor with new relay ,typical issue with compressor staying on due to stuck on relay. Now after replacing all the parts i notice the red LED lights for the suspension s... |
View | |
| 2005 Nissan Pathfinder LE 4.0L Starting VIN: 5N1AR18U95 my wife lost the key, I went to the nissan dealer & got a new key but Iam having trouble programming it, I need the NATS pin code the one I used is 9589 but did not work does any body have the right code. please help dealer wants 150 to program it. thanks in a... |
View |
Fixes & Summaries for All Makes and Models
| Fix/Summary | Answers | |
| 2010 Chevrolet Equinox LT 2.4L Stall VIN: 2CNFLEEW1A To be clear, I did not personally fix this vehicle. I was not ready to pull the trigger since we NEVER got this thing to act up and had ZERO data. There was an aftermarket service contract company involved, and I, having dealt with plenty of them over the ye... Trouble codes: P0506 (Idle lower than expected). |
5 | |
| 2009 GMC Canyon WT 2.9L MIL Lamp on, VIN: 1GTCS14929 Customer pulled truck to send to dealer, good luck to whomever gets it. 2 replies centered on alt with A/C voltage. Already went there, tested for it and went ahead and replaced anyway as listed in help request. I do believe the problem lies with BCM miss-read... |
3 | |
| 2012 Jeep Wrangler Unlimited Sahara 3.6L Horn VIN: 1C4HJWEG0C Thanks to everyone who replied. The Jeep finally came back into the shop and I replaced the steering wheel switch pack. Problem solved! |
8 | |
| 2004 Mazda RX-8 1.3L No Start VIN: JM1FE17344 well it runs now, got engine started by just cranking on it till it started which was several battery run down attempts, after it started I used a vacuum hose to suck in some top engine cleaner. now it starts better than its ever started since its been at the ... |
13 |
