P2196 Diagnostic Trouble Code Discussion for July 2014
Heated Oxygen Sensor (Bank 1 Sensor 1) Stuck Rich
Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.Trouble Ticket Help Requests for DTC P2196
| Help Request | Posted | |
| 2006 Ford Taurus SE 3.0L MIL Lamp on VIN: 1FAFP53U36 Came back with 2196 2198 codes and misfires. Of course not missing here but customer stated no power shaking ETC. Found Front (bank 2) O2 switching much slower than rear bank 1. Replaced with NGK sensor (denso not available same day here) Switching better bu... |
July 02, 2014 | |
| 2007 Lincoln Navigator Ultimate 5.4L MIL Lamp on VIN: 5LMFU28597 Koeo all o2 sensors under .02 volts, after starting sensors go to 900mv as soon as heaters turn on. Checked oil for fuel vapors, none clean oil. Disconnected purge line to tank, no change, create large vacuum leak numbers go down. Disconnected both front o2 se... |
July 11, 2014 | |
| 2010 Audi Q7 Premium 3.6L MIL Lamp on VIN: WA1VYAFE2A P2196: 008598 B1S1 SIGNAL TOO HIGH Rich. Hi Techs, I have this 3.6 litre that is apparently too lean on bank 1. When I look at block 032 Im sitting at .8% and .6%. Block 033 -4.7% @1.54v and -4.7% @1.5v. Block 036 .14v and .70v both saying the the o2 sensor are ok. All of my lambda number are at 1.00... |
July 25, 2014 |
