Join Now
International Automotive Technicians Network

P0011 Diagnostic Trouble Code Discussion for July 2012

Camshaft 1 Position Sensor Target Performance (Bank 1 Sensor 1)


Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Trouble Ticket Help Requests for DTC P0011
Help Request Posted
2005 Subaru Legacy GT Limited 2.5L Poor Idle Quality, Hesitation, Stall, Misfire, MIL Lamp on VIN: 4S3BL67615
P0011: Camshaft Position - Timing Over-Advanced / System Performance (Bank 1). This car runs poorly, stalls @ idle and has the codes listed below. I was able to make it run better for 1 key cycle by clearing the codes and adaptations. Second key cycle it started running bad again. We checked cam/crank timing which is ok. The turbo looks ...
July 03, 2012
2005 Nissan 350Z Grand Touring 3.5L Lack of power VIN: JN1AZ36AX5
P0011: Intake Valve Timing Control Range/Performance (Bank 1). ... vehicle inbecasue he could not get into gear. Deterined it was pressure plate issue, removed trans and it appeared he had been having fun. Was told by the supplier of the flywheel it could be machined so we did clutch works fine, but has no power and codes...
July 23, 2012
2005 Subaru Legacy GT Limited 2.5L Poor Idle Quality, Hesitation, Stall, Misfire, MIL Lamp on VIN: 4S3BL67615
P0011: Camshaft Position - Timing Over-Advanced / System Performance (Bank 1). This car runs poorly, stalls @ idle and has the codes listed below. I was able to make it run better for 1 key cycle by clearing the codes and adaptations. Second key cycle it started running bad again. We checked cam/crank timing which is ok. The turbo looks ...
July 03, 2012
2005 Nissan 350Z Grand Touring 3.5L Lack of power VIN: JN1AZ36AX5
P0011: Intake Valve Timing Control Range/Performance (Bank 1). ... vehicle inbecasue he could not get into gear. Deterined it was pressure plate issue, removed trans and it appeared he had been having fun. Was told by the supplier of the flywheel it could be machined so we did clutch works fine, but has no power and codes...
July 23, 2012