P0336 Diagnostic Trouble Code Discussion for February 2011
Crankshaft Reference Sensor Performance
Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.Trouble Ticket Help Requests for DTC P0336
| Help Request | Posted | |
| 2005 Chevrolet Workhorse 4.8L No Start VIN: 5B4HP42V15 Truck has repeatedly left the driver sitting and later restarts, it was towed in during a freezing rain storm in a no start condition.When we went to get the truck out of the lot (on a dry day) it started runs fine data stream looks normal.Have performed wiggl... |
February 03, 2011 | |
| 1996 Chevrolet Impala SS 5.7L Misfire, MIL Lamp on P0336: DI Crankshaft Position Sensor Performance. HEY GUYS, I,ve been working on this car for 3 days straight,even on my birthday.This one is really kicking my butt. Car came in for a N.J. state inspection.Check engine light was glowing.I pulled codes. The first one was a air pump code. No big deal,seized a... |
February 04, 2011 | |
| 2001 Hyundai Accent GL 1.6L No Start, Poor Idle Quality, Stall, Misfire, MIL Lamp on VIN: KMHCG45C81 P0336: Crankshaft Position Sensor Circuit Range/Performance. Car came in with no start. No spark, no injector pulse and code PO335 stored. Checked crank sensor resistance:852Mohm. Replaced sensor with new one which measured 850 ohm. With new sensor, had intermittant spark and injector pulse, still would not run. Tried s... |
February 16, 2011 | |
| 2007 Mercedes-Benz C230 Sport 2.5L No Start VIN: WDBRF52H67 Seems to be a crank sensor faulty, replaced crank sensor, but vehicle fails to start. Checked input refrence voltage to crank sensor 5v. Ground ok output signal from sensor ok. Also no power to the fuel pump at all. Checked all fuses, relays, power and ground ... |
February 16, 2011 | |
| 2000 GMC Safari SL 4.3L No Start VIN: 1GTDM19W0Y P0336: Crankshaft Reference Sensor Performance. ... had 2 rods gone i jump started the van and drove the van ito the shop. when you do this you lift the van off of the front suspension and the wiring harness goes with it i did not unplug the crank sensor but removed it with the harness attached. after trans... |
February 17, 2011 |
