P1106 Diagnostic Trouble Code Discussion for September 2008
MAP Sensor Circuit Intermittent High Voltage
Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.Trouble Ticket Help Requests for DTC P1106
| Help Request | Posted | |
| 1998 Honda Civic LX 1.6L MIL Lamp on VIN: 2HGEJ6675W P1106: BARO Pressure Sensor Performance. ... turnig on the cel for dtc p1106. alldata has no diag info or repair. it just says reset ecm the run engine at 3000 rpm if dtc returns ecm is bad, the baro sensor is in the ecm. has anyone run into this problem anf would be helpful. thanks dave |
September 04, 2008 | |
| 2000 GMC Sierra 1500 SL 4.3L No Start VIN: 1GTEC14W7Y P1106: MAP Sensor Circuit Intermittent High Voltage. has spark has fuel pressure has injector pulse all injectors ohm 11.7 to 11.9 will start and run with fuel poured down the throttle body has injector pulse checked the fuel for e85 it checked ok for gas and truck will run on the fuel out of the tank when poure... |
September 17, 2008 | |
| 1996 Chevrolet C1500 Cheyenne 5.7L Excessive Emissions, Poor Idle Quality, Stall, Misfire, MIL Lamp on, RUNS RICH VIN: 2GCEC19R2T P1106: MAP Sensor Circuit Intermittent High Voltage. this p/u is driving us nuts...customer stated that all of a sudden vehicle started running poorly shortly after fill up ( coinsidence?) misfires piling up on 1,3,6,8...lots of black smoke and MIL on w/ MAP/MAF codes. after lots of testing and parts swapping wo... |
September 26, 2008 | |
| 1996 Chevrolet Lumina 3.1L MIL Lamp on VIN: 2G1WL52MXT P1106: MAP Sensor Circuit Intermittent High Voltage. car came in with p1106 code. vacc 19in idle. cked map showed .20 volts all the time, so i tried new map and on test drive would only go to 2 volts on hard accel. normal idle was.7 to .8 volts. so i start alldata tree. koeo unplugged map shows .o2 volts. next c... |
September 29, 2008 |
