P0102 Diagnostic Trouble Code Discussion for April 2008
Mass Airflow Sensor Circuit Low Voltage
Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.Trouble Ticket Help Requests for DTC P0102
| Help Request | Posted | |
| 2005 Mazda 6 S 3.0L Poor Idle Quality, Hesitation, Surge, Cuts out, Stall, MIL Lamp on P0102: Mass Airflow Sensor Circuit Low Input. used engine installed and transmission rebuildt.at times will start and die.other times will start and stay running but idle surge and die.i did test drive vehcile and lacks power. engine runs only after tcs lamp comes on.i have erased dtcs but immediately ret... |
April 03, 2008 | |
| 2003 Ford Excursion XLT 6.0L Misfire VIN: 1FMSU41P73 P0102: maf. ... miss, but only after vehicle was warmed up. Sometimes he can drive it all day and never experience a problem. Test drove and after about 10 miles sure enough, it was missing like a gas engine with bad plug wires. Idling and cold it purrs like a kitten. Ran... |
April 11, 2008 | |
| 1999 GMC K2500 Sierra SLE 7.4L Hesitation, Cuts out, Stall, MIL Lamp on VIN: 1GTGK23J6X P0102: MAF Sensor Circuit Low Frequency. ... installed reman longblock customer pick up and drove fine for about a week.then it stated stumbling on him. got the truck back at the shop found codes p0102 checked maf and it is not having any activity replaced drove and did ok for a short time and code c... |
April 14, 2008 | |
| 1999 GMC K2500 Sierra SLE 7.4L Hesitation, Cuts out, Stall, MIL Lamp on VIN: 1GTGK23J6X P0102: MAF Sensor Circuit Low Frequency. ... installed reman longblock customer pick up and drove fine for about a week.then it stated stumbling on him. got the truck back at the shop found codes p0102 checked maf and it is not having any activity replaced drove and did ok for a short time and code c... |
April 16, 2008 | |
| 1999 Cadillac Seville STS 4.6L No Start, MIL Lamp on VIN: 1G6KY5490X P0102: MAF Sensor Circuit Low Frequency. After replacing the engine, started vehicle and a code (po102 MAF sensor low input signal) was stored and the check light is on. The MAF sensor is reading 106 hertz @ idle and with ignition on and it is supposed to be more than 1135 hertz @ idle. So i checked ... |
April 22, 2008 |
