P0137 Diagnostic Trouble Code Discussion for March 2008
Heated Oxygen Sensor (Bank 1 Sensor 2) Circuit Low Voltage
Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.Trouble Ticket Help Requests for DTC P0137
| Help Request | Posted | |
| 2000 Oldsmobile Silhouette GL 3.4L Surge VIN: 1GHDX13F3X P0137: Heated Oxygen Sensor (Bank 1 Sensor 2) Circuit Low Voltage. Help, GM techs! This vehicle is owned by a very good customer of ours. The 2 complaints, are Check Engine Light coming on (numerous times last year - most not documented) and jerking while driving down the road after a hot run, such as interstate driving then ... |
March 07, 2008 | |
| 2000 Isuzu Trooper LS 3.5L Surge, Stall, MIL Lamp on VIN: JACDS58XOY P0137: Heated Oxygen Sensor (Bank 1 Sensor 2) Circuit Low Voltage. Hi, all. Customer normally uses vehicle for close local driving, within 25 miles, and has not been a problem. Recently her husband has to go to Houston weekly for cancer treatment, and it is on these 150 mile one way trips that it acts up, running at least a c... |
March 19, 2008 | |
| 2000 Isuzu Trooper LS 3.5L Surge, Stall, MIL Lamp on VIN: JACDS58XOY P0137: Heated Oxygen Sensor (Bank 1 Sensor 2) Circuit Low Voltage. Hi, all. Customer normally uses vehicle for close local driving, within 25 miles, and has not been a problem. Recently her husband has to go to Houston weekly for cancer treatment, and it is on these 150 mile one way trips that it acts up, running at least a c... |
March 24, 2008 | |
| 1999 Chevrolet Express 2500 5.7L Excessive Emissions, Hesitation, Cuts out, Poor Fuel Economy VIN: 1GCGG25R8X P0137: Heated Oxygen Sensor (Bank 1 Sensor 2) Circuit Low Voltage. at idle this van runs great. engine will rev just fine on light excell, but med. to heavy excell it will not rev over 1200-1500 rpm. backfires through intake. falls flat on its face. fuel pressure in spec.koeo and 55psi when acting up. cam retard at 0- +1 degr... |
March 25, 2008 |
