P0335 Diagnostic Trouble Code Discussion for May 2007
Crankshaft Position Sensor Circuit Malfunction
Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.Trouble Ticket Help Requests for DTC P0335
| Help Request | Posted | |
| 1999 Chevrolet Astro 4.3L Poor Idle Quality, Hesitation, Misfire, MIL Lamp on VIN: 1GNDM19W3X P0335: CKP Sensor Circuit Malfunction. van came from another shop with rebuilt engine complaining about hesitating,no start and idle.they installed cam,crank sensors.i scoped and scaned engine,everything looked good except idle,too high.I changed cap,rotor,wires,that seemed to remedy the no start t... |
May 03, 2007 | |
| 2005 Dodge Grand Caravan SXT 3.8L long crank time VIN: 2D4GP44L85 P0335: Crankshaft Position Sensor Circuit Malfunction. Vehicle has extended crank time when cold or after sitting for some time.Sometimes wont start for some time.Occasionally vehicl will start and die but will restart fine. Reference voltage to the crank sensor is fine and the ground is ok. I changed the crank se... |
May 09, 2007 | |
| 1999 Chevrolet Astro 4.3L Poor Idle Quality, Hesitation, Misfire, MIL Lamp on VIN: 1GNDM19W3X P0335: CKP Sensor Circuit Malfunction. van came from another shop with rebuilt engine complaining about hesitating,no start and idle.they installed cam,crank sensors.i scoped and scaned engine,everything looked good except idle,too high.I changed cap,rotor,wires,that seemed to remedy the no start t... |
May 13, 2007 | |
| 2003 Chevrolet Silverado 1500 4.3L Stall VIN: 2GCEC19X33 P0335: CKP Sensor Circuit Malfunction. vehicle came in from another shop.they cahnged ckp.they did not shim it.cusatomer opted to do new improved timming cover amd sensor with shim kit.one week later came back with crank and cam (ckp& cmp ) codes. |
May 16, 2007 | |
| 2001 Chevrolet Blazer LS 4.3L Cuts out, Misfire, MIL Lamp on VIN: 1GNCS13W21 P0335: Crankshaft Position Sensor Circuit Malfunction. ... week. I have scoped crank and cam sensors, also ignition system primary and secondary. It all looks good on the scope. I use genisys OTC. The problem is what ever is setting the code p0335. There is information from GM on this code but I can not get it. So... |
May 26, 2007 |
