P0133 Diagnostic Trouble Code Discussion for November 2004
Heated Oxygen Sensor (Bank 1 Sensor 1) Slow Response
Note: This is a professional automotive technician's resource.
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.Trouble Ticket Help Requests for DTC P0133
| Help Request | Posted | |
| 2001 Volvo S40 1.9L MIL Lamp on, Runs fine VIN: YV1VS29541 P0133: Front O2 sensor Short term fuel trim Faulty signal. ... setting a P0133 code. I've check fuel pressure. It's OK. Check vacuum hoses. All look good. Checked 02 sensors and tried a new front one for the hell of it. Still reset code. I checked intake gasket with spray. no change. Checked canister purge valve to se... |
November 01, 2004 | |
| 1997 Ford Explorer Eddie Bauer 5.0L MIL Lamp on VIN: 1FMDU35P2V P0133: HO2S11 ckt slow response. Hello,have a vehicle that the mil has been on for a year. Tk started to run poorly and customer brought it in. I found numerous O2 codes and tk would enter closed loop with all O2's reading less than .1v. Checked all wires at O2 2/1. found good ground on sig r... |
November 02, 2004 | |
| 1998 Ford Windstar GL 3.8L MIL Lamp on VIN: 2FMZA5144W P0133: o2s slow response bank1 sensor 1. thanks to all in advance, this windstar once in a while will set the above mentioned codes with no drivabillity issues, so the first time it came in we scaned and did a visual under the hood, we found the pcv hose in bad shape and leaking, so that was fixed an... |
November 18, 2004 | |
| 1996 Volvo 850 GLT 2.4L MIL Lamp on VIN: YV1LW5548T P0133: B1 S1 slow response. ... Thanksgiving, In a nutshell, we replaced the O2 sensors on this 850 for P0133 (slow response) on sensor 1 & a no activity code on sensor 2. The sensors are direct fit Bosch from WorldPac. Had to disconnect the battery terminals and short them togeth... |
November 25, 2004 | |
| 2000 Volvo S40 1.9L mil VIN: YV1VS29501 P0133: bank 1 short term fuel trim. mil & code set within 15 of clearing, smoked for vacuum leaks, fuel pressue in spec. o2 sensor swings fine and rapidly ( below .2v above .8v and very quicly). is there anything else to look at? thanx jamie |
November 26, 2004 |
